SATOFFEE WEB INSTALLER
1- Flash software
- Connect your Lilygo T-Display-S3 to the USB port on your device
- Press the "🔥 Flash software" button
- Follow screen instructions
- After successfull flashing go to step 2 below and load config
Your browser does not support installing things on ESP devices. Use Google Chrome or Microsoft Edge.
Ah snap, you are not allowed to use this on HTTP!
2- Load config values
Important: don't send any commands to the device before entering in "config mode".
- Connect your Lilygo T-Display-S3 to the USB port on your device
- Put Satoffee in "Serial config mode"
- If no config values it will start automatically after 15 seconds.
- If there are config values start the "serial config mode" pressing left button for 5 seconds.
- Press the "🔌 Connect" button
- Select your device and connect
- Press the "📖 Read Config" button to read values
- Change to your own values
- Press the "🔥 Write Config" button
- Disconnect and you are ready to use
Troubleshoot
If non of the above works, reset board in boot mode and start over.
- Connect the board via the USB cable
- Press and hold the BOOT button
- While still pressing the BOOT button, press RESET
- Release the RESET button
- Release the BOOT button
- Go to step 1